TOP SPORTS

Road Bike
Mountain Bike
Running
Outdoor
Hiking Trekking
Winter Sports
Alpine Skiing
Team Sports

CUSTOMER CARE

Terms & Conditions
Refer a friend
Guarantee registration
Store Locator
Imprint

GUIDES & MORE

Biking Bib Tight Guide
Under Guide
Ski Socks Guide

AS SEEN IN 

 

Best in Test
Publication
Blogs

© 2019 by Unite Creative Design Co.,Ltd.

Compression sportswear PP Polypropylene U.CR + Human body sweat torso (TORSO) Thermal and wet comfort assessment report84.6% water will evaporate, evaporate within 12 minutes, warm body temperature can also cool down 1.6 degrees.General quick drying clothes are mostly in the cloth to evaporate. Because U.CR + is the idea of ​​sweating quickly derived, will not stick in the skin slowly evaporate. The following is the experimental processST2 PP sweat body surface temperature (ie skin temperature) and weight changes are continuously recorded. The three stages of this test are divided into adaptation, exercise and recovery.The sweat trunk has 54 individually controlled precision water valves, which are heated using a hot foil plate. The entire cylinder is distributed with 13 temperature sensors to measure and control the temperatureThermal resistance value Rct (Figure 1)In the first stage (warm-up) sweat the trunk surface temperature is maintained at 35 ° CTemperature difference / TST temperature change curve (Figure 2 & 3)In the second stage after sweating the temperature (medium strength) results, T10 temperature rise of 0.55 ℃ and T60 cooling to -1.67 ℃. Due to ventilation and heat conduction. A lot of sweating but a sense of coolness.The third stage of post-exercise chills. The drying time of this sample is about 12 minutes in the third stage. (Chang Geng rehabilitation of the body measured about 10 minutes to start drying)Comparison of water vaporization / retention profiles (Figure 5)St2 PP pressure clothing is ideal for quick-drying textiles. This monolayer sample evaporates about 84.6% of the sweat volume at the end of the second stage. And after 12 minutes dry. (U.CR + 102 years of textile research program)

 

運動壓力衣 compression sportswear PP 聚丙烯U.CR+ 人體流汗軀幹(TORSO)熱濕舒適性評估報告84.6%水會蒸發 , 12分鐘內蒸發完,暖身時還體溫可降溫1.6度。一般快乾衣服是在布面蒸發大部份。因為U.CR+就是主張將汗水快速導出來,不會粘在皮膚慢慢蒸發。 以下是實驗過程ST2 PP 流汗軀幹表面溫度(即膚溫)和重量變化都持續被記錄下來。此測試的三階段分為適應期、運動期和恢復期。流汗軀幹具有54個獨立控制的精密水閥,加熱的方式係使用電熱箔板,整個圓柱體分佈了13個溫度感測器以量測並控制溫度熱阻抗值Rct(圖1)在第一階段(暖身) 流汗軀幹表面溫度維持35°C溫度差異/TST溫度變化曲線(圖2&3)在第二階段流汗後溫度(中強度)結果,T10升溫為0.55℃而T60降溫為-1.67℃。因通風散熱導汗佳。大量流汗反而有涼感。第三階段出現的運動後寒顫(post-exercise chill)。此樣品的乾燥時間在第三階段約為12分鐘。(長庚復健所測約人體約10分鐘開始乾燥)水分蒸發/滯留分布比較(圖5)St2 PP 壓力衣是理想的速乾紡織品。此單層樣品在第二階段終了時可蒸發約84.6%的流汗量。且在12分後就乾。(U.CR+ 102年紡研科專計畫)Compression sportswear PP Polypropylene U.CR + Human body sweat torso (TORSO) Thermal and wet comfort assessment report84.6% water will evaporate, evaporate within 12 minutes, warm body temperature can also cool down 1.6 degrees.General quick drying clothes are mostly in the cloth to evaporate. Because U.CR + is the idea of ​​sweating quickly derived, will not stick in the skin slowly evaporate. The following is the experimental processST2 PP sweat body surface temperature (ie skin temperature) and weight changes are continuously recorded. The three stages of this test are divided into adaptation, exercise and recovery.The sweat trunk has 54 individually controlled precision water valves, which are heated using a hot foil plate. The entire cylinder is distributed with 13 temperature sensors to measure and control the temperatureThermal resistance value Rct (Figure 1)In the first stage (warm-up) sweat the trunk surface temperature is maintained at 35 ° CTemperature difference / TST temperature change curve (Figure 2 & 3)In the second stage after sweating the temperature (medium strength) results, T10 temperature rise of 0.55 ℃ and T60 cooling to -1.67 ℃. Due to ventilation and heat conduction. A lot of sweating but a sense of coolness.The third stage of post-exercise chills. The drying time of this sample is about 12 minutes in the third stage. (Chang Geng rehabilitation of the body measured about 10 minutes to start drying)Comparison of water vaporization / retention profiles (Figure 5)St2 PP pressure clothing is ideal for quick-drying textiles. This monolayer sample evaporates about 84.6% of the sweat volume at the end of the second stage. And after 12 minutes dry. (U.CR + 102 years of textile research program)Color: 白.灰 Size: S、L 68% Polypropylene 聚丙烯 20% Nylon 12% Spandex穿著短車衣內搭網洞背心在訓練時,很明顯的可以發現:

 

1.最先濕透的是完全沒有衣服的前臂,都是汗珠,汗量最大

 

2.接下來肩膀到前臂只有車衣短袖的部分會濕透貼住

 

3.車衣+網洞背心的部分則是最乾的區域,這個地方會最慢才全濕。體感上有網洞背心的地方有明顯的差別,就算最後全身都濕透的時候,也不會有貼黏感。

運動壓力衣 compression sportswear

快乾Dry Fit 

PP 聚丙烯 St2 U.CR+ 人體流汗軀幹(TORSO)熱濕舒適性評估報告84.6%水會蒸發 , 12分鐘內蒸發完,暖身時還體溫可降溫1.6度。一般快乾衣服是在布面蒸發大部份。因為U.CR+就是主張將汗水快速導出來,不會粘在皮膚慢慢蒸發。 以下是實驗過程ST2 PP 流汗軀幹表面溫度(即膚溫)和重量變化都持續被記錄下來。此測試的三階段分為適應期、運動期和恢復期。流汗軀幹具有54個獨立控制的精密水閥,加熱的方式係使用電熱箔板,整個圓柱體分佈了13個溫度感測器以量測並控制溫度熱阻抗值Rct(圖1)在第一階段(暖身) 流汗軀幹表面溫度維持35°C溫度差異/TST溫度變化曲線(圖2&3)在第二階段流汗後溫度(中強度)結果,T10升溫為0.55℃而T60降溫為-1.67℃。因通風散熱導汗佳。大量流汗反而有涼感。第三階段出現的運動後寒顫(post-exercise chill)。此樣品的乾燥時間在第三階段約為12分鐘。(長庚復健所測約人體約10分鐘開始乾燥)水分蒸發/滯留分布比較(圖5)St2 PP 壓力衣是理想的速乾紡織品。此單層樣品在第二階段終了時可蒸發約84.6%的流汗量。且在12分後就乾。(U.CR+ 102年紡研科專計畫)

 

職業自行車隊

法國馬賽/西班牙ECZ職業自行車隊,選用為Mesh Basic layer 第一層肌膚排汗衫,若是沒有St2PP,車隊團體福將會黏貼肌膚,產生不舒適感,大大降低戰力。腹部和水量最大,需要大量通風效果,一般車衣較不易達成效果,唯有全開網洞可達到通風冷卻效果。

 

室內瑜珈

瑜珈老師需要輕薄彈力大,T-PP Mesh 極適合室內瑜珈所用,手感舒適又有快乾功能。網洞透氣,女性只要再穿運動內衣可產生島和及美感體態。

U.CR+ PP mesh long sleeve super light 超輕量無縫網洞內衣-長袖

NT$1,200.00Price
size